PaintNuts Colour Matched Pen set with Paint, Lacquer, Primer & Rust Converter

STEP ONE - PaintNuts Rust Converter 2 in 1 Pen

1. Clean surface by removing all loose paint, rust, dirt, grease and salt.
2. Rinse with clean water and allow time to dry.
3. Shake the pen for 1 minute ensuring the converter is mixed.
4. By brush apply direct to rusty area, working well into heavily pitted areas, corners and edges.
5. By needle point pen allow the nib to sit in the stone chip and gentle squeeze the pen allowing the converter to flow in to the chip.
6. Avoid coating onto painted areas, remove any excess with a clean cloth.
7. The rust converter will turn blue/black when reacting with rust, normally within 15 minutes, if it does not change colour in 1 hour re-apply.
8. PaintNuts primer can be applied after 2 hours.

STEP TWO - PaintNuts Primer Touch Up Pen

• Mixing - Shake pen thoroughly for at least 1 minute to ensure the primer is mixed correctly.
• Preparation - The surface must be clean and dry - make sure all wax, polish and dust is removed. If rust is present we suggest a rust treatment using PaintNuts Rust Converter 2 in 1 pen.
• Application - Using either pen or brush apply thin, light coats in smooth strokes; if you’re using the needle point pen allow the nib to sit inside the scratch or chip and squeeze gently ensuring you only apply the primer within the damaged area. Leave the primer to dry for upto 30 minutes before applying any further coats, if no further coat is required, then leave to cure for 1 full hour before applying the PaintNuts Colour Matched Touch Up Pen.

STEP THREE - PaintNuts Colour Matched Touch Up Pen

• Mixing & Colour Check - Shake the Paint Pen for at least 3 Minutes to ensure the paint is thoroughly mixed correctly (if your paint is a Metallic Paint, you may notice the paint has separated within the bottle, this paint will need a vigourous shake, then test in a discreet area to check the colour match leaving the paint to dry for 10 minutes – paints will often appear different in colour inside the bottle, when wet or if applied incorrectly.
• Preparation - The surface must be clean and dry - make sure all wax, polish and dust is removed.
• Application - Using either the metal nib/pen or brush apply thin, light coats in smooth strokes; if you’re using the needle point pen allow the nib to sit inside the scratch or chip and squeeze gently ensuring you only apply the paint within the damaged area. Do Not apply new paint on top of existing paint as this will leave the area of repair looking lighter or darker. Leave the colour matched paint to dry for upto 30 mins before applying any further coats, if no further coat is required, then leave to cure for 1 full hour before applying the PaintNuts Clear Lacquer. 

STEP FOUR - PaintNuts Clear Lacquer Touch Up Pen

• Mixing - Shake pen thoroughly for at least 1 minute to ensure the lacquer is mixed correctly.
• Preparation - The surface must be clean and dry - make sure all wax, polish and dust is removed.
• Application - Using either pen or brush apply thin, light coats in smooth strokes; if you’re using the needle point pen allow the nib to sit in the scratch or chip and squeeze gently ensuring you only apply the lacquer witin the damaged area. Leave the lacquer to dry for upto 30 minutes before applying a second coat if required, if no further coat is required, you must leave the lacquer to cure for 4 hours before you use any buffing or polishing solution/compound.